Axles and gears from Moser. Diff (Torsen, new, not take-off) from Ebay, 2nd new Torsen diff minus "paddle" from Ebay (actually the first one ordered), and the install kit (bearings/shims) came either from Moser or Summit. The diff cover/girdle (which is installed) came from Summit. The "extra" axle assembly came from some lying A-hole up near Berlin. Said that the car that it came out was not in an accident and the panhard bar was bent by a forklift moving it around. After installing the "replacement" rear, the rear brakes would not work. (car was on jackstands) Took a good look at the rims and they were "wobbling". (bent axles) Had to re-use the axles that were in my "blown up" rear to get the car driveable again. Parts cost about 1/2 to 1/3 the cost of a new rear minus labor.
Don't know if I'll be installing the parts or not (want to but...) as I'll be leaving for Ft. Jackson this June after 10 years in Germany.
