| F-Body Europe http://forum.fbodyeurope.org/phpBB3/ |
|
| Crankshaft questions http://forum.fbodyeurope.org/phpBB3/viewtopic.php?f=11&t=6173 |
Page 1 of 1 |
| Author: | 99GT [ Fri Dec 02, 2005 7:04 am ] |
| Post subject: | Crankshaft questions |
What's the difference between 305 and 350 crankshafts with a 2 piece rear main seal? My book shows the stroke and journal sizes are the same. Would a 305 crankshaft work in a 350 using 350 rods and pistons? Thanks, Dan |
|
| Author: | NXZ28 [ Fri Dec 02, 2005 10:54 am ] |
| Post subject: | |
Should be the same. The only real difference between the 305 and 350 was the piston bore size. |
|
| Author: | Roy [ Fri Dec 02, 2005 11:16 am ] |
| Post subject: | |
Dan Have you been to Nasty's page . Gots pretty good info on SBC. |
|
| Author: | 99GT [ Fri Dec 02, 2005 12:25 pm ] |
| Post subject: | |
Gents, Thanks for the info. That is a good site. The cranks do interchange. I think I have my next Chevy project. Dan |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|