F-Body Europe
http://forum.fbodyeurope.org/phpBB3/

these UPS guys keep ringing my doorbell :-)
http://forum.fbodyeurope.org/phpBB3/viewtopic.php?f=11&t=6481		 Page 1 of 1
Author:  jeejee [ Tue Apr 18, 2006 9:55 pm ]
Post subject:  these UPS guys keep ringing my doorbell :-)
Image


instead of putting a dish in a set of forged pistons i still had , and compromising piston top thickness (strenght) i ordered a special set in hopes of a stronger piston ..

The dish looked a bit deeper then i thought it would need to be , so i measured it and they fabricated a 21cc dish and not the 15cc i asked :evil:
Compression becomes now really too low for a good thorttle response (autoX"......)
, so i propably sent them back, or stack them for a future turbo project

Why do they do that :?:
Not listen to the customer and make something he didn't ask for.....

otherwise, the quality looks nice and the coating should help get the friction down somewhat
Author:  SRZ [ Wed Apr 19, 2006 7:52 am ]
Post subject: 
Man keep and just up the boost! :D That's a stout looking crown on there too.
Author:  TurboManiacal [ Wed Apr 19, 2006 2:12 pm ]
Post subject: 
SRZ wrote:
Man keep and just up the boost! :D That's a stout looking crown on there too.


Get a smaller exhaust housing. ;)
Author:  Garry [ Wed Apr 19, 2006 2:22 pm ]
Post subject: 
yeah ... do it like the ricers, 1/2" from the engine to the end, then 8" tip :) :lol:
Author:  Squirrelina [ Thu Apr 20, 2006 5:16 pm ]
Post subject: 
:roll:
Author:  jeejee [ Fri Apr 21, 2006 10:45 pm ]
Post subject: 
TurboManiacal wrote:
SRZ wrote:
Man keep and just up the boost! :D That's a stout looking crown on there too.


Get a smaller exhaust housing. ;)



Hmmmmm .. i don't think that will help much on this one ..... :P

Image
Author:  Squirrelina [ Sat Apr 22, 2006 7:09 am ]
Post subject: 
...and I thought my garage was a mess. u need to clean up. :lol:
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/