Hello I'm selling a few parts to free up space.
These parts came off a vehicle that was NOT currently running, it would run for about 4 seconds before shutting off. The previous owner planned a cam swap, but did not do his research. The engine went back together with its original cam and never ran properly again. I believe that if reassembly had not been rushed to such an extreme it would have ran again.
90 corvette TPI intake system this will include:
1) intake manifold (base, runners, plenum, fuel rail with injectors; note: fuel line connectors exit to the front passenger side)
2) complete engine wiring harness from 90 Corvette, nothing cut, but I did brake the plastic housing that meets with the firewall
3) distributor, this is the large cap distributor with the ignition coil integrated on top of the cap
4) ECM This is out of a 90 Corvette so it has the cover for mounting in the engine compartment (note: this is equipped with VATs I have everything to go with it, however it is still in the car and I would recommend a new chip with Vats disabled)
If interested in individual parts feel free to pm me, price for all is $500 obo.
I also have a 94 LT1 bare block with heads I'm trying to get rid of. This was purchased from ham sandwhich on this board about a year ago. I bought it as a "back up" engine with the intention of slowly building it up, but have not really done anything with it so it has to go.
LT-1 pulled from a '94 A4 Camaro. Bored .30 over and Sleeved. Stock Crank. Stock heads. Stock intake with injectors, rails, harness, ECM. Also Clevite 77 Rod & Main bearings.
$500 obo
I'll try and post pics tonight when I get home
thanks, Ken.