Has anyone of you ever removed the ABS module (EBCM)?
Removal itself is not a problem, however, I've read the following instructions:
"To install, clean BPMV gasket surface with alcohol.
Install NEW wave spring(s) in original location and position between
EBCM and BPMV. Install EBCM to BPMV. Install 4 NEW top mounting screws
and tighten in an "X" pattern. Install 2 NEW bottom screws and
tighten."
Why NEW screws and NEW springs?
Is this the same as with the screw/bolt that holds the brake caliper that SHOULD be new when changing pads/rotors but can be reused without a problem?
Thanks!