Get a 2 1/4 pipe, and have the local craft shop expand one end to make it fit. That is too easy!
| F-Body Europe http://forum.fbodyeurope.org/phpBB3/ |
|
| Exhaust adapter needed! http://forum.fbodyeurope.org/phpBB3/viewtopic.php?f=32&t=5386 |
Page 1 of 1 |
| Author: | slickmetal.com [ Fri Feb 04, 2005 10:07 am ] |
| Post subject: | Exhaust adapter needed! |
Hey all... I need an exhaust adapter to go from my Y - pipe (3") to 2 1/4" for my stock I pipe....something that I can remove when I get a full 3" I-pipe (later) AAFES does not have one...maybe they have one down @ the KMC area. |
|
| Author: | JackZ28 [ Fri Feb 04, 2005 12:34 pm ] |
| Post subject: | |
Get a 2 1/4 pipe, and have the local craft shop expand one end to make it fit. That is too easy!
|
|
| Author: | Roy [ Sat Feb 05, 2005 8:09 am ] |
| Post subject: | |
you think you would get it to expand that far? |
|
| Author: | Garry [ Sat Feb 05, 2005 8:16 am ] |
| Post subject: | |
Hm ... when I needed an adapter for the Jeep exhaust, a local car place (well, mainly for businesses, they carry stuff up to truck sizes and beyond) had dozens of different pipes ... with those sizes, I think regular car places will be a bit understocked  Check a truck supply place ...
|
|
| Author: | Squirrelina [ Sat Feb 05, 2005 9:06 am ] |
| Post subject: | |
I heared there is a place in Siegelbach near K-Town which is specialized on exhaust pipes and welding of such ... not cheap though. I will see if I can find out the address again. Nice wheater, thought I take the T-Top for the shopping tour now the battery is dead... argh! |
|
| Author: | Garry [ Sat Feb 05, 2005 10:06 am ] |
| Post subject: | |
Saw a guy in an open 'vert yesterday ... thick jacket, and most likely heater turned all the way up, as it was close to freezing ... |
|
| Author: | JackZ28 [ Sat Feb 05, 2005 10:43 am ] |
| Post subject: | |
I think so Roy, but I haven't actually seen it done. That's only 3/8ths of an inch all the way around.  I guess it also depends on the pipe used.
|
|
| Author: | Roy [ Sat Feb 05, 2005 11:14 am ] |
| Post subject: | |
Thats as a good stretch, pipe would have to be very malleable. |
|
| Author: | JackZ28 [ Sat Feb 05, 2005 11:20 am ] |
| Post subject: | |
You're right. It might not be that easy. I'm just trying to put suggestions out there.
|
|
| Author: | SRZ [ Tue Feb 15, 2005 3:27 pm ] |
| Post subject: | |
I've sent you a pm slick. You get it? |
|
| Author: | Daddy [ Tue Feb 15, 2005 6:16 pm ] |
| Post subject: | |
That sure wouldn't be hard from the guy at Kapaun |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|