| F-Body Europe http://forum.fbodyeurope.org/phpBB3/ |
|
| Sway Bar connection rods (or whatever they may be called) http://forum.fbodyeurope.org/phpBB3/viewtopic.php?f=32&t=7337 |
Page 1 of 1 |
| Author: | Garry [ Mon Apr 02, 2007 5:12 am ] |
| Post subject: | Sway Bar connection rods (or whatever they may be called) |
Swapping sway bars & PH between Camaro and Firebird, the inevitable happened ... the stock rods tha connect the sway bar end links to the body on the Firebird were slightly  rusted, so out of the four rods, I was able to get one out that didn't break in the process ...
So I could use two sets of rods, one front, one rear ... anybody happen to have any take-offs flying around? Otherwise, I will just see if I can pick up something similar here ... |
|
| Author: | ChrisV6 [ Mon Apr 02, 2007 9:02 am ] |
| Post subject: | |
I snapped also all of them everytime i tried to remove them from a car, stopped when i replaced that endlinks with a set from energy suspension... |
|
| Author: | Garry [ Mon Apr 02, 2007 9:03 am ] |
| Post subject: | |
The BMR ones were almost like new ... hardly any corrosion, no rust ... would have sucked if they too had snapped ... 
|
|
| Author: | Chevroletfreak [ Mon Apr 02, 2007 3:55 pm ] |
| Post subject: | |
I may have some. Remind me if I don't get back to you. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|