Pulled the tranny 3 times, on my second clutch slave cylinder (dont ask
) and still I cant seem to get it right.
Basically here is the deal. Act as if this was a clutch install and your down to the last 2 bolts to re-hook up the slave. Obviously Im not getting the shift fork to engage?!? What is the last thing you do, I have pushed it up until it acted like it engaged the throw-out bearing, but it always wants to slip down.
Pry bar, BFH, Large Screwdriver motivation?
Give me your play by play of when you did it.
By the way, nothing fancy or changed, its a spec clutch, they have that kinda squarish throw out instead of a pretty round one, but it has been on there before, so by god I know it works
Thanks