Just thought I would post this here to see if there is interest. I have no idea who the person is.
usually i would not put something like this on this site but i figured why not. I need this gone and someone may know someone that may want it.
Item Description -632 C.I. Pontiac/ Oldsmoble full race eng
Asking/Offering Price -see below
Email Address
-jimibanda@yahoo.com
Your Location -San Antonio
Pics (if available) -on request, serious buyers only
Here is all the specs on it
632 cubic inch Pontiac/Oldmoble
New Donovan 4.600 bore block- 0 runs 0 dyno pulls
Bryant 4.750 crank
New Brooks Rods
New JE Pistons And pins-16.3 comp ratio
Smith Bros. push rods
Comp lifters
CamMotion Cam .860 Intake .810 Exhaust 288 & 308 degree at .050
114degree intake lobe center
sheetmetal 2 dominator intake w/ burst panels
manifold plumbed rear to front water lines
manifold plumbed for twinfogger
2qft dominators w/billet metering blocks (1150's)
14degree Brodix Heads 2.450 intake and 1.88 exhaust valves (Titanium)
new comp 948 springs
Jesel Rocker system and timing belt system
Heads ported by Lozano bro. porting 481 cfm intake and 320 exhaust
Moroso valve cover
3 stage drysump system
MSD front mount distributor
MSD crank trigger
ATI harmonic balencer
Moroso drysump pan
Nitrous systems and fuel system available (with tune)
this engine before the rebuild and new block dyno at 1182hp to the crank before nos....Can handle 600 shot of nos 3 stage.
this is a great engine. but my shop is building up a bigger one so this one is just gathing dust at the shop.
Serious buyer only please.
18,000 is the asking price on this bad boy...and thats good considering the rebuild alone goes about 10 grand..this is a 37000 dollar motor easily.